![]() Then you get to route the window defroster wire through the soft top sleeve and stuff but that's way too hard to explain without pics.Run the seatbelt through the new plastic trim, install the reused plastic plugs into the trim and snap it into place. After removing soft-top structure, the HardTop add more resonance.Mine came with 2 sets of bolts for the bottom hole, it didn't seem to matter which I used but I thought that was weird. Install the mounting posts using the supplied bolts. 2003 Toyota MR2 Spyder 2dr Convertible (1.8L 4cyl 5M) The whole point of designing this car with a 'limited' engine was to minimize insurance costs and to avoid the luxury tax.The HT should have come with 2 new trim parts with sections of them cut out to accommodate the hard top mounting posts. Remove the left and right plastic trim parts that the seat belt passes through (unbolt the seatbelt base).Replace them with the stainless latch parts.LEFT HAND DRIVE TOYOTA MR2 SPYDER ROADSTER 1.8 VVT-i 2 DOOR. Remove the rear tabs near the engine hinge that are body colored painted on the Left and Right side. Find amazing local prices on used Toyota MR2 cars for sale Shop hassle-free with Gumtree, your local buying & selling community.but if no one posts up I can send you a scan of the install info via PM on Sunday. It was a few years ago so I don't remember the actual instructions. Those things above aren't in any instructions but two things I noticed I messed up on the first hard top install. Did it come with all mounting hardware and modified plastic trim pieces?Ģ things on that - when you pull the seatbelts through the old trim pieces, be careful not to pop the retaining rivet off of the seatbelt when you pull it through the plastic trim that is being replaced.Īlso, when installing the new plastic trim using the plastic rivet(s) that holds it in place, do not push too hard otherwise you will 'crease' the trim and create a white mark from pushing to hard (like when you fold a credit card in half, you get that white stress line from bending plastic).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |